TM 5-5420-202-20-3
ROADWHEEL ARM REPLACEMENT (Sheet 6 of 7)
1.
Remove covering from roadwheel support
housing opening.
Apply a light coat of grease to outer edge of
2.
new inner grease seai.
3.
Position inner grease seal (A) into roadwheel
housing (B) opening so BACK of seal (A) goes in
towards hull. You should be able to see
FRONT of seal (A) as you look into housing.
4.
Using oil seal replacer and handle tap lightly
on handle with hammer until inner seal has
bottomed in housing (B).
5.
Coat all parts on upper spindle (C) with
grease.
6.
Install new gasket (D) to mounting face of
retainer (E).
CAUTION
Do not use excessive force while
installing roadwheel arm; damage
to seal may result.
NOTE
Upper spindIe (C) must be properly
alined with support housing (B)
while roadwheel arm (F) is being
installed.
7.
Using two persons, install upper spindle (C)
completely into support housing (B).
GO on to Sheet 7
