TM 5-5420-202-20-3
STEERING CONTROL CLEVIS AND STUD REPLACEMENT (Sheet 2 of 3)
REMOVAL:
Using 9/16 inch wrench, remove bolt (A)
from link (B).
2.
Using 9/16 inch wrench, remove bolt (C)
from clevis (D).
3.
Remove rod (E).
4.
Using rule, measure center to center distance of holes in rod end (F) and clevis (D).
5.
Using pencil and paper, write down center to center distance.
6.
Using 9/16 inch wrench to hold rod end (F), use another 9/16 inch wrench to loosen jamnut
(G).
Using 9/16 inch wrench, remove rod end (F) and jamnut (G).
Go on to Sheet 3
TA249640
15-17