TM 5-5420-202-20-3
CONNECTING LINK REPLACEMENT (Sheet 2 of 2)
INSTALLATION:
Position washer (A) and connecting link (B) onto shaft (C).
1.
Position connecting rod (D) onto clevis of connecting link (B) and secure with bolt (E).
2.
Install connecting rod (F) onto connecting link (B) and secure with bolt (G).
3.
4.
Using 9/16 inch wrench, tighten bolts (E and G).
Install washer (H) and shield (J) onto shaft (C) and, using 7/16 inch wrench, install and
5.
secure washer (K) and screw (L) into shield (J).
6.
Using 3/4 inch wrench, install and secure washer (M) and nut (N).
7.
Using pliers, install cotter pin (P).
Install powerplant (page 5-14).
8.
End of Task
TA249648
15-25