TM 5-5420-202-20-3
FRONT FENDER (CENTER LEFT AND RIGHT) STOWAGE BOX COVER REPAIR (Sheet 4 of 4)
Place lock (E) in position on stowage cover (B).
5.
Using blacksmith's anvil and hammer, install
6.
six new rivets (F).
7.
Place handle (G) in position on lock (E).
8.
Place tongue (H), washer (J), and nut (K) on
handle (G).
Place stowage box cover (B) in position on
9.
stowage box.
10.
Using 9/16 inch wrench, install twelve
screws (L) and lockwashers (M) securing
four hinges (N) and six tapping plates (P)
to cover (B).
Close cover (B) and check for positive
latching of handle (G). Add shim washers (Q)
as necessary to assure positive latching.
Using 11/16 inch wrench, tighten nut (K)
12.
until hole in handle (G) alines with groove in
nut.
Using pliers, install new cotter pin (R).
Using pliers, install S-hook (S).
Install stowage box on vehicle (page 16-77).
End of Task
TA249756
16-83