TM 5-5420-202-20-3
REAR FENDER (LEFT AND RIGHT) STOWAGE BOX COVER REPAIR (Sheet 1 of 4)
PROCEDURE INDEX
PAGE
PROCEDURE
Disassembly
Cleaning and Inspection
Assembly
TOOLS: 11/16 in. combination box and open end wrench
Long round nose pliers
Putty knife
Blacksmith's anvil
9/16 in. combination box and open end wrench
2 lb. hammer
Punch (drive pin 1/8-inch diameter point)
Electric drill and drill set
SUPPLIES: Adhesive (Item 2, Appendix D)
Cotter pin
Rivets
Lockwasher (8 required)
Pads (2 required)
Washer, shims (as required)
Remove stowage box from vehicle
PRELIMINARY PROCEDURE:
DISASSEMBLY:
NOTE
Repair of both left and right
covers is identical.
1.
Using pliers, remove cotter pin (A) from handle
(B).
2.
Using 11/16 inch wrench, remove nut (C),
washer (D) and tongue (E) from handle (B).
3.
Remove handle (B) from stowage box cover (F).
Go on to Sheet 2