TM 5-5420-202-20-4
PERSONNEL SEAT ASSEMBLY REPAIR (Sheet 3 of 5)
Using hammer and 1/8 inch punch, remove
10.
two short pins (L) from handle (M).
11.
Remove handle (M), latch (N), and spring (P).
12.
Using hammer and 1/4 inch punch, drive
out eight nuts (Q).
13.
Inspect all parts for damage or wear;
replace parts as required.
ASSEMBLY:
1.
Using hammer and 1/8 inch punch, install eight nuts (A).
2.
Using hammer, install new short pin (B) in handle (C).
3. " Position spring (D) on handle (C)..
4.
Position handle (C) through hole in seat (E).
5.
Position latch (F) on handle (C) with
holes alined.
6.
Using hammer and punch, install new short
pin (G) in handle (C).
Go on to Sheet 4
TA248591