TM 5-5420-202-34
SUSPENSION
Shock Absorber Bearing Replacer
9.
Remove and replace bearings in shock absorber
(11654533)
mount.
Bearing Tool Assembly
10.
Remove No. 1 left and right roadwheel arm
(12325917)
track adjusting bearing.
Remove and replace bearing in grease actuated
Bearing Driver (12290993)
11.
track adjusting link.
Loosen or tighten locking collar on grease actu-
Spanner Wrench (12301553)
12.
ated track adjusting link.
Test grease actuated track adjusting link after
Adjusting Link Test Fixture (12326061)
13.
repairs.
SMOKE GRENADE LAUNCHER
Position stowage box mounting bracket.
Locating Fixture Assembly (12257682)
14.
SPARE AND REPAIR PARTS
Spares and repair parts required for direct support and general maintenance of this vehicle are listed and
illustrated in TM 5-5420-202-24P which is the authority for ordering replacement parts.
Section II. SERVICE UPON RECEIPT
1.
This section contains information on services to be performed upon issue of the vehicle to
the using organization. Where practicable, the crew will assist in services described. Some
of the services contained herein may not be required, depending upon the degree of
preservation provided by the shipper and the planned use of the vehicle.
2.
Cut hold-down straps and remove wooden boxes, containers of equipment, and any other
vehicle components secured to the exterior or interior of the vehicle.
a. Inspect the equipment for damage incurred during shipment. If the equipment has been
damaged, report the damage on DD Form 6, Packaging Improvement Report.
b. Check the equipment against the packing slip to see if the shipment is complete.
Report all discrepancies in accordance with the instructions of DA PAM 738-750.
3. Conduct service upon receipt of the chassis in accordance with the procedures specified on
refer to TM 5-5420-228-24 and TM 5-5420-203-14.
2-2 Change 2
