TM 5-5420-202-34
CLEANER FAN REPAIR (Sheet 6 of 7)
5.
Using a rule, measure distance between
outside end of vanes and flange on motor
(C).
6.
This distance should be 1-5/8 inch. If
distance is not correct, remove impeller
(D) and add on (or take away) shim washers
(B) as necessary.
7.
Using socket with ratchet, install nut
(E) again.
8.
Install new packing (F) in motor groove.
Using hammer, install spring pin (G) in
9.
housing (H) by gently tapping pin into
hole until it bottoms.
NOTE
I t will be necessary to guide
capacitor leads (J) through openings
of housing (H) and motor (C) prior
to step 10.
10.
Insert leads (J) and capacitor (K) into
mounting place on housing (H) and through
opening in flange of motor (C).
11.
Install motor (C) into housing (H) alining
hole in motor flange with pin (G) in housing
flange.
Using screwdriver, install four screws
12.
(L) and lockwashers (M) securing capacitor
(K).
Go on to Sheet 7
4-7
