TM 5-5420-202-34
AIR CLEANER FAN REPAIR (Sheet 2 of 7)
5.
Remove preformed packing (J) from
motor (K).
6.
Using 1/4 inch flat-tip screwdriver, remove
screw and washer (L) securing ground
strap (M).
7.
Using 1/4 inch flat-tip screwdriver, remove
screw and washer (N), securing retaining
strap (P), brush lead (Q), and power lead
(R).
8.
Slide insulator (S) aside to expose lead
(R). Pull lead (R) apart at connector
and remove insulator (S) by sliding forward.
Using 1/4 inch flat-tip screwdriver, remove
9.
four screws (T) and lockwashers (U) scouring
capacitor and leads (V). Pull leads and
capacitor (V) out from housing (D).
10.
Holding motor (K) in one hand, tap housing
(D) with hammer to loosen motor from
housing. Remove motor (K) from housing
(D).
11.
Using pliers, remove spring pin (W) from
housing (D).
Go on to Sheet 3
