TM 5-5420-202-34
10.
Remove lens (Q) and lamp (R) from light housing (S).
Using knife, remove insulation sleeving from two terminals on light housing (S).
11.
12.
Using masking tape, tag and mark wires (T).
Using soldering iron, unsolder two wires (T) from terminals on light housing (S).
13.
Using wrench, remove nut (U) and lockwasher (V) holding light housing (S) to cover
14.
(C).
Remove light housing (S) from cover (C).
15.
16.
Using screwdriver, remove four
(X) that hold electrical connector
(Y) to case (D).
Pull connector (Y) with wiring attached
17.
from case (D) so you can get to the
wiring (Z).
Using knife, remove insulation sleeving
18.
from four pins of connector (Y).
19.
Using masking tape, tag and mark each
wire (Z).
20.
wires (Z) from pins of connector
(Y).
21.
Remove connector (Y) and gasket
(AA) from case (D).
Go on to Sheet 6
12-5