TM 5-5420-202-34
GRENADE LAUNCHER CONTROL POWER BOX REPAIR (Sheet 6 of 7)
ASSEMBLY:
1.
Using soldering iron and solder,
solder four wires (A) to proper pins
on connector(B).
2.
Remove tags from four wires (A).
3.
Put 1/2" long piece of insulation
sleeving on four wires (A).
4.
Put insulation sleeving over
pins of connector (B).
5.
Using heat gun, shrink insulation sleeving.
6.
Put four wires (A) through gasket (C) and
case (D).
7.
Put gasket (C) and connector (B) on case
(D) and align holes.
8.
Using screwdriver, attach connector (B)
to case (D) with four lockwashers (E) and
four screws (F).
9.
Using wrench, attach light housing (G) to cover (H) with lockwasher (J) and nut (K).
10.
Put 1/2" long piece of insulation sleeving over two wires (L).
11.
12.
Remove tags from wires (L).
13.
Put insulation sleeving over soldered terminals of light housing (G).
14.
Using heat gun, shrink insulation sleeving.
15.
Install lamp (M) and lens (N) onto light housing (G).
Go on to Sheet 7
12-6
