TM 5-5420-203-14
c . Assembly of the MLC 70 Bridge - CONT
(4) Installation of Near Shore Lateral
Brace.
NOTE
Be sure previously attached components
line up on same side of clip angles as
opposite section.
(a) Align the lateral brace (1) with
holes on the bottom flange of the
inside girders of bridge sections
(2) and (3). Place four bolts (4)
through holes with heads of bolts
to the top.
(b) Tighten bolts (4).
NOTE
The pintles of the transverse braces are
threaded.. Transverse brace must be
oriented so flag assembly bolt holes are
located as shown in inset.
(5) Installation of Near Shore Rear
Transverse Brace.
(a) Position the rear transverse brace
(5) so holes align with clip angles
on sections.
(b) Insert four bolts (6) through clip
angles and thread into transverse
brace (5).
(c) Tighten four bolts (6).
2-40 Change 2
