TM 5-5420-203-14
c . Assembly of the MLC 70 Bridge - CONT
(13) Installation of Far Shore Rear Transverse Brace
NOTE
The pintles of the transverse braces are threaded. Transverse brace must be oriented
so flag assembly bolt holes are located as show in inset.
(a) Position the rear transverse brace (1) so holes align with clip angles on bridge sections
(b) Insert four bolts (2) through clip angles and thread into transverse brace (1).
(c) Tighten four bolts (2).
(14) Installation of Far Shore Second Rear Transverse Brace.
NOTE
The transverse brace is installed with the slots in the brace on the bottom.
(a) Position the second rear transverse brace (3) so holes align with clip angles on bridge
sections.
(b) Insert four bolts (2) through clip angles and thread into transverse brace (3).
(c)Tighten four bolts
Change 2 2-45
