TM 5-5420-203-14
FAR-SHORE RAMP SECTION REPLACEMENT (Sheet 2 of 2)
d. Disconnect flexible hydraulic line (9) from
separated ramp section (7). Position line (9) out
of harm's way.
e. Using lifting device and sling, move separated
ramp section aside.
INSTALLATION
INSTALL FAR-SHORE RAMP SECTION (7).
NOTE
Ensure that disconnected braces and diaphragm falls on the correct side of clip angles, or
in position for alinement for connecting.
Ensure transverse, lateral braces, and diaphragm are located on or in the correct position
q
for mounting before continuing. If not, disconnect ramp section from center section and
reposition, then reconnect.
a. Using lifting device and sling, position
replacement ramp section (7) in line with
center section (8). Leave about 1 foot
separation between ramp section and center
section.
b. Connect disconnected flexible hydraulic line
(9) located on center section (8) ramp section
(7). Ensure connection is tight.
c. Using lifting device and sling, position
ramp section (7) so the end connectors (10)
of sections (7) and (8) will aline for pinning.
Be sure components mounted to remaining
ramp section aline with the attaching clip
angles of ramp section (7).
d. Insert four pins (6) through mated end
connectors (10). Insert four retainers (5)
through installed pins (6).
e. Ensure manual hydraulic bleed valves (1)
and (2) located within the protective
housings (3) on both end of hydraulic
cylinder (4) are closed.
END OF TASK
3-49
