TM 5-5420-203-14
RAMP SECTION DECK EXTRUSION REPLACEMENT (Sheet 2 of 4)
NOTE
Flat washer (item 11) serves as a spacer between the varying width deck extrusions. Refer
to TM 5-5420-203-24P, Repair Parts and Special Tools List (RPSTL) for identification of
the replacement flat washer (spacer) needed. Alteration of the flat washer (shaving,
sanding, and cutting) to fit is not authorized.
e. Slide screw (10) back until it releases
flat washer (spacer )(1 1).
f. Remove flat washer (13) and screw (10)
from deck extrusions (5 and 12).
NOTE
Steps g. and h. are for removal of the
lifting bar (14).
g. Remove two nuts (15) and two lock
washers (16) securing lifting bar (14) in
position. Discard lock washers.
h. Remove lifting bar (14) and two screws (17).
NOTE
Removal of male electrical retainers
requires the removal of attached deck
extrusions. The number of mounting
screws varies.
i. Refer to the alphabetical lettering on the
illustration and remove four deck extrusions
marked A, B, and C in accordance with
steps a. thru h. above.
j. Remove four deck extrusions with male
electrical retainer (18) attached as a unit.
3-53
