TM 5-5420-209-12
Paragraph
Page
4-98.
Hinge Pins, Link and Hardware . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-335
4-99.
Foldlock . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4-339
4-100.
Tee Latch and Travel Latch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4-341
4-101.
Cable Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-343
4-102.
Receptacles . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-345
4-103.
Connectors and Hardware . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .....4-347
4-104.
Connecting Pin, Grunions, and Lever . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-349
4-105.
Bumpers . . . . . . . . . . . . . . . . . . . . . . . .. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-351
4-15. General. This section contains unit level Maintenance Procedures as authorized by the MAC in Appendix B of
this manual. Some maintenance procedures may require more than one person. Ensure adequate number of personnel
are available before performing maintenance procedure.
4-16. Painting. General instructions for painting the ribbon bridge transporter interior bay, and ramp bay are included
in TM 9-213, AR 746-5, and TB 746-93-1.
4-17. Floodlights.
This task covers:
a. Replace
b. Repair
INITIAL SETUP
Tool
Equipment Condition:
General Mechanic’s Automotive Tool Kit
Floodlight switch in OFF position.
(Item 1, Appendix B)
Materials/Parts
Solvent, Dry Cleaning (Item 18, Appendix E)
Rags, Wiping (Item 12, Appendix E)
NOTE
There are two floodlights on the transporter. The maintenance procedures are the same for both.
a. Replace. (figure 4-1)
(1) Tag and disconnect wiring from floodlight (1).
(2) Remove two nuts (2) and washer (3).
(3) Remove floodlight (1) and washer (4).
(4) Install washer (4) on new floodlight (1).
(5) Install floodlight (1) and secure with washer (3) and two nuts (2).
(6) Connect wiring as tagged to floodlight (1).
4-36
