TM 5-5420-209-12
4-28. Roller and Axle Assembly. - Continued
b. Replace(Rear). (figure 4-19)
(1) Remove two screws (1), washers (2), spacers (3) and remove trunion (4) and spring (5).
(2) Swing rod (6) out of way.
(3) Remove cotter pin (7).
(4) Remove nut (8), and remove axle (9), washer, two thrust washers (11), and roller.
(5) Remove grease fitting (12) from axle (9).
WARNING
Dry cleaning solvent PD-680 used to clean parts is potentially dangerous to personnel and property.
Avoid repeated and prolonged skin contact. Do not use near open flame or excessive heat. Flash point
of solvent is 100-138 °F (38-60 °C).
(6)
(7)
(8)
(9)
(10)
(11)
(12)
Clean all items in dry cleaning solvent, and dry thoroughly.
Replace all items that are excessively worn or otherwise damaged.
Install grease fitting (12) in axle (9).
Apply grease to axle (9).
Mall axle (9), two thrust washers (11), roller (13), washer (10) and secure with nut (8).
Install cotter pin (7).
Swing bar (6) into position and install spring (5) and trunion (4) and secure with two screws (1), washers (2)
and spacers (3).
4-72
