TM 5-5420-209-12
4-29. Rear Winch Assembly. - Continued
b. Disaasembly ( Model 11-S-EC) (figure 4-21)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
Remove two pipe plugs (1) and (2).
Remove snap ring (3) and remove end cover (4) and preformed packing (5).
Remove thrust plate (6).
Remove final planet assembly (7) from final drive housing (8).
Drive pin (9) into shaft (10) and remove shaft (10) and gear (11) from hub (12).
Press bearing (13) out of gear (11).
Repeat Steps (5) and (6) for remaining gears.
Use blocks and support drum (14).
Remove four screws (15), washers (16), and nuts (17) and remove final drive housing (8).
Remove shaft (18).
Remove retaining ring (19), preformed packing (20) and taper seal ring (21 ) from drum (14).
4-76
