TM 5-5420-209-12
4-38. Rollers and Pins.
This task covers: Replace
INITIAL SETUP
Tool
Equipment Condition:
General Mechanic’s Automotive Tool Kit
Bay removed (para. 2-16).
(Item 1, Appendix B)
Materials/Parts
Grease, Automotive and Artillery (Item 2, Appendix E)
Rags, Wiping (Item 12, Appendix E)
a. Replace. (figure 4-42)
NOTE
Maintenance procedures are for both the winch cable roller and pin, and bay roller and pin.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
Remove cotter pin (1), nut (2), pin (3) and bay roller (4).
Remove two cotter pins (5), washers (6), pin (7), and roller (8).
Remove grease fitting (9) from pin (3).
Install grease fitting (9) in pin (3).
Apply grease to fitting (9) until clean grease appears from pin (3). Wipe off excess grease.
Position bay roller (4) in channel and install pin (3).
Secure pin (3) with nut (2) and cotter pin (1).
Apply grease to pin (7).
Position winch cable roller (8) in channel and install pin (7).
Secure pin (7) with two washers (6) and cotter pins (5).
4-150
