TM 5-5420-209-12
4-49. Tiedown Hook and Attaching Hardware.
This task covers:
a. Replace
b. Repair
INITIAL SETUP
Tool
Equipment Condition:
General Mechanic’s Automotive Tool Kit
Rear roller and axle assembly removed.
(Item 1, Appendix B)
Materials/Parts
Solvent, Dry Cleaning (Item 18, Appendix E)
Rags, Wiping (Item 12, Appendix E)
a. Replace. (figure 4-43)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
Remove two cotter pins (1), pin (2), and remove rod (3).
Unscrew bolt (4) from yoke (5) and remove yoke (5) and tiedown hook (6).
Press out pin (7) securing tiedown hook (6) to yoke (5).
NOTE
Gain access to spring pin (8) through spring pin access hole (9).
Using suitable punch, remove spring pin (8).
Hold nut (10) and remove bolt (4), and nut (10).
Remove quick release pin (11) from holder (12).
NOTE
Perform Step (8) only if quick release pin is to be replaced.
Cut wire rope (13) and remove quick release pin (11 ).
Install quick release pin (11 ) in holder (12).
Secure wire rope (13) to frame (14).
Install nut (10) and bolt (4) and tighten bolt (4) until hole in nut (10) aligns with hole in bolt (4).
Install spring pin (8) in nut (10) and bolt (4).
Position tiedown hook (6) in yoke (5) and secure with pin (7).
4-152
