TM 5-5420-209-12
4-45. Selector Valve.
This task covers: Replace
INITIAL SETUP
Tool
Equipment Condition:
General Mechanic’s Automotive Tool Kit
Bay removed (para. 2-16).
(Item 1, Appendix B)
Materials/Parts
Tape, Antiseize (Item 19, Appendix E)
a. Replace. (figure 4-50)
WARNING
When disconnecting any hydraulic lines, open slowly and protect face as
due to residual pressure in system.
NOTE
When removing hoses, have a suitable container to drain oil from hoses.
immediately to prevent dirt or foreign matter from entering the system.
(1) Tag and disconnect three hydraulic lines (1) from selector valve (2).
hydraulic fluid may spray out
Also cap all hoses and ports
(2) Remove two nuts (3), lockwashers (4), screws (5), and selector valve (2).
(3) Install selector valve (2) and secure with two screws (5), lockwashers (4), and nuts (3).
(4) Apply antiseize tape to hydraulic fittings on selector valve (2) and connect three hydraulic
lines (1).
4-166
