TM 5-5420-209-124-43. Cylinder Assembly.This task covers: ReplaceINITIAL SETUPToolEquipment Condition:General Mechanic’s Automotive Tool KitBay removed (para. 2-16).(Item 1, Appendix B)Materials/PartsAntiseize Tape (Item 19, Appendix E)a. Replace.(figure 4-48)WARNINGWhen disconnecting any hydraulic lines, open slowly and protect face as hydraulic fluid may spray outdue to residual pressure in system.NOTEWhen removing hoses, have a suitable container to drain oil from hoses. Also cap all hoses and portsimmediately to prevent dirt or foreign matter from entering the system.(1)(2)(3)(4)(5)(6)(7)Tag and disconnect two hydraulic lines (1) and (2) from cylinder (3).Support cylinder (3).Remove cotter pin (4) and pin (5) securing clevis (6) to arm (10).Remove cotter pin (7), pin (8) and cylinder (3).Position cylinder (3) and front support (9) and secure with pin (8) and cotter pin (7).Align clevis (6) with arm (10) and secure with pin (5) and cotter pin (4).Apply antiseize tape to hydraulic, fittings on cylinder (3) and connect two hydraulic lines (1) and (2) to cylinder(3) as tagged.4-162
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business