Front Support.

Figure 4-81. Bogie Lock and Brackets, Replace.

TM-5-5420-209-12 Cargo Pallet Ribbon Bridge Transporter (NSN 5420-01-008-7436) Manual
Page Navigation
419

4-61. Front Support. This task covers: Replace INITIAL SETUP General Mechanic’s Automotive Tool Kit (Item 1, Appendix B) Lifting Device Equipment Conditions: Cab protector removed (para. 4-58). Selector valve removed (para. 4-45). Throttle control removed (para. 4-39). Front rollers removed (para. 4-28). Equipment Conditions: - Continued Dual over center valve (front) removed. Walkways removed (para. 4-26). Locking cylinder pin, arm and quick release pin removed (para. 4-42). Tire carrier assembly removed (para. 4-27). Locking cylinder removed (para. 4-43). Hydraulic filter assembly removed (para. 4-49). Control valve removed (para. 4-44) (para. 4-58). a_“Replace. (figure 4-82) WARNING When working under boom, support boom by blocking or other suitable means. (1) Remove two nuts (2) and screws (3) securing front support (4) to fuel tank mounting bracket (5). (2) Remove eight nuts (6), screws (7) and spacer plates (8). (3) Remove six nuts (9), screws (10), and spacer plates (11). (4) Remove three nuts (12), screws (13), and spacer plates (14). CAUTION Ensure all hydraulic lines, fuel lines, and electrical leads are removed from front support, or damage to the equipment could result. (5) Connect suitable lifting device to front support (4) and remove front support (4) from chassis (16). (6) Install front support (4) on chassis (16). (7) Install spacer plates (14) and secure with screws (13) and nuts (12). Torque screws to 85-95 ft-lbs (115-129 Nm). (8) Install spacer plates (11) and secure with screws (10) and nuts (9). Torque screws to 85-95ft-lbs (115-129 Nm). 4-226 TM 5-5420-209-12 Tools

Privacy Statement
Press Release
Contact