TM 5-5420-209-12
4-106.
Receptacles.
This task covers: Replace
INITIAL SETUP
Tool
Equipment Condition:
General Mechanics Automotive Tool Kit
Bay removed (para. 2-16).
(Item 1, Appendix B)
a. Replace. (figure 4-139)
(1) Unlatch (open) travel latch (1).
(2)
Remove four bolts (2), lockwashers (3), nuts (4), and remove strike catch (5) and shim (6).
(3) Remove four bolts (7), lockwashers (8), nuts (9), and remove latch receptacle (10), and
shim (11).
NOTE
Do not fully tighten nuts at this point.
(4) Install latch receptacle (10) and shim (11), and secure with four bolts (7), lockwashers (8), and nuts (9).
(5) Install strike catch (5) and shim (6), and secure with four bolts (2), lockwashers (3), and nuts (4).
(6) Latch (close) travel latch (1) and check clearance between pins (12) of travel latch (1) and latch receptacle
(9) and strike catch (5). Clearance should be approximately 0.0625 in. (0.1587 cm).
(7) Adjust strike catch (5) and latch receptacle (10) as needed and torque nuts to 31-34 ft-lbs
(42-46 Nm).
4-338