4-107.
Connectors and Hardware.
This task covers: Replace
INITIAL SETUP
Tool
Equipment Condition:
General Mechanics Automotive Tool Kit
Bay unfolded (para. 2-14).
(Item 1, Appendix B)
a. Replace. (figure 4-140)
NOTE
The procedures to replace connector are the same for all connectors.
(1) Remove spring (1) from connector (2) and eye bracket (3).
(2) Remove two screw (4) and remove eye bracket (3) and connector (2).
(3) Remove pin (5) and remove connector (2).
(4) Position connector (2) on eye bracket (3) and secure with pin (5).
(5) Install eye bracket (3) and connector (2) and secure with two screw (4). Torque screws (4) to 120-132 in.
(162-178 Nm).
(6) Install spring (1) on eye bracket (3) and connector (2).
4-340
TM 5-5420-209-12