ARMY TM 5-5420-212-10-1
MARINE CORPS TM 08676A-10/1-1
(2) LONG OR SHORT RAMP LIFTS WHEN TRAFFIC CROSSES BRIDGE
a.
Check ramp for correct installation.
Install ramp correctly.
b.
Check for missing anti-lift lug on ramp or bankseat beam.
If lug is missing from ramp unit, replace ramp.
If lug is missing from bankseat beam, watch ramp to ensure that it does not come off during crossing of traffic.
After operation, replace ramp or bankseat beam and report condition to Unit Maintenance.
(3) SWAY BRACE WILL NOT CONNECT TO BANKSEAT BEAM, BOTTOM OR END TAPER PANEL
a.
Ensure that roller beams are on same horizontal plane.
Level roller beams or position beams on same plane.
b.
Check girder spacing.
Move girders side to side.
c.
Inspect sway brace ends for burrs or gouged areas.
Use file to remove burrs or edge of gouged areas.
d.
Inspect sway brace brackets for burrs or gouged areas.
Use file to remove burrs or edge of gouged areas.
If sway brace will still not connect, replace sway brace. Report condition to Unit Maintenance.
(4) ROLLER BEAM JACK HOODS WILL NOT MOVE TO UP POSITION
a.
Ensure that roller catch is locked.
Lock roller catch.
b.
Ensure that fixed pins are pushed out.
Push pins out.
If hood will still not move to up position, replace roller beam. Report condition to Unit Maintenance.
(5) ROLLERS IN ROLLER BEAM OR ROCKING ROLLER WILL NOT TURN
a.
Ensure roller catch on roller beam is unlocked.
Unlock roller catch.
b.
Inspect rollers for damage.
Replace roller beam. Report condition to Unit Maintenance.
8-5