END TAPER PANEL, BANKSEAT BEAM, JUNCTION PANEL, TOP PANEL, BOTTOM PANEL, LAUNCHING NOSE HEAVY (Resilient Mount)

TM-5-5420-212-10-1 Improved Flaot Bridge Consisting of: Transporter Interior Bay Ramp Bay Manual
Page Navigation
513

ARMY TM 5-5420-212-10-1 MARINE CORPS TM 08676A-10/1-1 8-5. END TAPER PANEL, BANKSEAT BEAM, JUNCTION PANEL, TOP PANEL, BOTTOM PANEL, LAUNCHING NOSE HEAVY (Resilient Mount) This task covers: a. Removal b. Service/Repair c. Installation INITIAL SETUP: Tools Required 8 inch pliers Drift pin 1 lb ball peen hammer 6 inch screwdriver Materials Required Clean cloths Crocus cloth (25, Appendix D) Equipment Conditions Resilient mount in component. Component in upright position on raised, flat surface. No obstruction under bushing. a. Removal (1) Straighten prongs of cotter pin (1) with pliers and screwdriver (2) Remove cotter pin (1) from pin (2) with pliers. (3) Push on end of pin (2) until head of pin can be grasped, then pull pin from resilient mount (3) and housing (4). 8-10

Privacy Statement
Press Release
Contact