ARMY TM 5-5420-212-10-1
MARINE CORPS TM 08676A-10/1-1
WHITE STRIPE (FOR MULTI-SPAN BRIDGES)
HOLES NUMBERED 3, 5, 7, 9 AND 10
(FROM BOTTOM UP)
NOT USED ON U.S. MGB
YELLOW STRIPE (FOR DS BRIDGES)
HOLES NUMBERED 2, 4, 6, AND 8
(FROM BOTTOM UP)
HIGH POSITION 6 - BETWEEN HOLES 6 AND 8
MID POSITION 4 - BETWEEN HOLES 4 AND 6
LOW POSITION 2 - BETWEEN HOLES 2 AND 6
BLACK STRIPE (FOR SS BRIDGES)
HOLES NUMBERED 1, 2, 4 AND 6
(FROM BOTTOM UP)
HIGH POSITION 4 - BETWEEN HOLES 4 AND 6
MID POSITION 2 - BETWEEN HOLES 2 AND 4
LOW POSITION 1 - BETWEEN HOLES 1 AND 2
LAUNCHING NOSE CROSS GIRDER POST
(16) Launching Nose Cross Girder (LNCG)
The launching nose cross girder is used to hold the near bank end of the launching nose in the position set for
construction and launch.
(1)
PIN HOLES AND-JAWS. For insertion of captive pins to secure girder to posts.
(2)
ROLLERS. Bottom rail of heavy launching nose sections will run under rollers.
(3)
GRAVITY CATCH. Used to prevent over-launching of nose during construction.
(4)
CAPTIVE PINS. Used to secure girder to posts. Retainer clips must be used in captive pins.
(5)
IDENTIFICATION PLATE. The component serial number is marked on this plate.
1-40