TM 5-5420-226-20-3
MASTER CONTROL PANEL REPAIR (Sheet 52 of 73)
Personnel Heater Wiring Harness Replacement (Sheet 5 of 6)
INSTALLATION:
Apply silicone compound to male electrical end of connector (A).
1.
2.
Connect connector (A) to heater master switch (B) (circuit 400).
Using flat-tip screwdriver, secure electrical leads (circuits 400/405, 401, 402 and 407)
3.
with screws and washers to their respective terminals of switch, as shown.
Place switch (B) in position on panel.
4.
Place guard (C) on panel over switch (B).
5.
Using long nose pliers, install nut (D)
6.
and washer (E) securing guard (C) to
panel.
Go on to Sheet 6