TM 5-5420-226-20-3
HIGH VOLTAGE IR POWER SUPPLY AND SHOCK MOUNT ASSEMBLY REPLACEMENT
(Sheet 4 of 6)
NOTE
Mounting hardware used to mount power supply to brackets
is the same for three ends of brackets shown. Mounting
hardware for hidden bracket is described in step 4 below.
INSTALLATION:
1.
Position mount (A) on outside
of bracket (B).
Insert two screws (C) through inside
2.
of bracket (B) and mount (A).
Install lockwashers (D), and
3.
nuts (E) onto screws (C).
4.
Using 1/4 inch wrench to hold nut (E), use flat-tip screwdriver to tighten screw (C).
Using steps 1 through 4, install mounts (A) into each end of both brackets (B).
5.
Go on to Sheet 5
TA168806