TM 5-5420-226-20-3
SHIFTING CONTROL BRACKET AND LINK ASSEMBLY REPAIR (Sheet 8 of 11)
10.
Manually install nuts (K) and rod ends
(L) on stud (M).
NOTE
When adjusting clevises or
rod ends, make certain
that threads on control
tubes extend past the gage
opening in the rod end to
ensure a positive grip.
11.
Using two 9/16 inch wrenches and 6
inch rule, adjust rod ends (L) to obtain
the same center-to-center distance
between rod end holes as measured
and recorded in steps 3 and 4, DISASSEMBLY.
12.
Using torque wrench and crow foot adapter,
tighten nuts (K) against rod ends (L)
to 16-18 lb-ft (22-24 Nm).
TA169050
Go on to Sheet 9
11-49
