TM 5-5420-226-20-3
SHIFTING CONTROL BRACKET AND LINK ASSEMBLY REPAIR (Sheet 7 of 11)
ASSEMBLY:
1.
Position two washers (A) on link (B).
2.
Carefully position washers (A) and link
(B) in bracket (C) with all holes alined.
Position pin (D) under bracket (C) with
3.
pin hole alined with pin hole in bracket
(c).
Using hammer and 1/2 inch punch, install
4.
pin (D) through bracket (C), washers
(A), and link (B).
5.
Using hammer, install pin (E) through
pin hole in bracket (C) and shaft (D).
6.
Using 1/4 inch wrench, install grease
fitting (F).
7.
Using vise, install bearing (G) in bracket (C).
8.
Position link assembly (H) on bracket (C).
Using 3/4 inch wrench, install nut (J)
9.
on link assembly (H).
TA169049
Go on to Sheet 8
