TM 5-5420-226-20-3
BRAKE MASTER CYLINDER REPLACEMENT (Sheet 2 of 9)
REMOVAL:
1.
Using dry cleaning solvent and rags, clean master cylinder (A), both tube assemblies
(B) and (C), elbow (D), and stoplight switch (E).
NOTE
Care must be taken to prevent dirt from entering
brake system.
2.
using 1-1/8 inch socket, remove filler cap (F).
3.
using fingers, disconnect electrical connector (G) from stoplight switch (E).
4.
Using both hands, place funnel and container under elbow (D).
5.
Using pipe wrench, hold elbow (D).
6.
Using 1 inch deep style socket, remove stoplight switch (E).
7.
Drain all brake fluid from master cylinder into container through elbow (D).
Go on to Sheet 3
TA169133
13-3
