TM 5-5420-226-20-3
BRAKE FOOT PEDAL LEVER MOUNTING BRACKET REPLACEMENT (Sheet 3 of 6)
CAUTION
Sleeve bearings (P) installed in Ievers (F) and (G) at the bracket end are
resting against shoulders (Q). They must be removed from the inside as
shown.
Place lever (F) in vise. Using hammer
8.
and alining punch (R), remove bottom
sleeve bearing (P) from inside as shown.
Turn lever (F) over and repeat steps
to remove other sleeve bearing (P) at
bracket end. Remove sleeve bearing
(P) at pedal end.
Place lever (G) in vise. Using hammer and alining punch, remove bottom sleeve bearing
9.
(P). Turn lever over and remove remaining sleeve bearing (P).
CLEANING AND INSPECTION:
Cleaning agent specified is flammable. Use only in well ventilated areas. Keep away from
flames, sparks, or heat. Do not smoke while using. Prevent contact with eyes, mouth, and/or
skin. Wear rubber gloves when performing cleaning procedures.
1.
Using dry cleaning solvent and rags, clean and dry all parts.
Inspect all parts. Replace if unserviceable.
2.
TA169143
Go on to Sheet 4