TM 5-5420-226-20-3
BRAKE PRESSURE GAGE, TUBE ASSEMBLY, REDUCER, AND GASKET REPLACEMENT
(Sheet 2 of 7)
REMOVAL:
1.
Using dry cleaning solvent and rags,
clean master cylinder (A), brake tube
(B), tube connecting nuts (C) and (D),
elbow (E), and brake pressure gage as-
sembly (F).
2.
Using hands, place funnel and container
under tube connecting nut (D) to catch
brake fluid.
Using 1-1/8 inch socket, remove filler
3.
cap (G) from master cylinder (A).
4.
Using 3/4 inch wrench to hold reducer (H), use 9/16 inch wrench to remove tube con-
necting nut (D).
5.
After brake fluid has drained from master cylinder (A), use fingers to install filler cap
(G) to master cylinder.
6.
Using 3/4 inch wrench, remove reducer (H) and gasket (J). Throw gasket (J) away. Plug
hole with plastic plug.
Go on to Sheet 3
TA169164
13-36
