TM 5-5420-226-20-3
BRAKE SWITCH (STOPLIGHT) REPLACEMENT (Sheet 2 of 4)
REMOVAL:
Using dry cleaning solvent and rags,
1.
clean master cylinder (A), elbow (B),
stoplight switch (C), electrical connector
(D), and general area.
Using hands, place funnel and container
2.
under elbow (B) to catch brake fluid.
Using fingers, disconnect electrical
3.
connector (D) from stoplight switch
(c).
Using 1 inch deep style socket, remove stoplight switch (C).
4.
Using plug, plug elbow (B) to prevent excessive loss of brake fluid.
5.
CLEANING AND INSPECTION:
Cleaning agent specified is flammable. Use only in well ventilated areas. Keep away from
flames, sparks, or heat.Do not smoke while using. Prevent contact with eyes, mouth and/or
skin. Wear rubber gloves when performing cleaning procedures
1.
Using rags and dry cleaning solvent, clean all parts before installation.
Inspect elbow (B) for worn threads. Replace if unserviceable.
2.
Inspect electrical connector (D) and lead in wires for cracks and worn spots. Replace
3.
if unserviceable.
TA169161
Go on to Sheet 3
