TM 5-5420-226-20-3
PARKING BRAKE CABLE ADJUSTMENT (Sheet 1 of 4)
TOOLS:
15/16 in. open end wrench (2 required)
Ratchet with 1/2 in. drive
Slip joint pliers
6 in. ruler
Torque wrench with 1/2 in. drive (0-175 lb~ft) (0-237 Nm)
SPECIAL TOOL: 9/16 in. crowfoot with 1/2 in. drive ( Chapter 3, Section I)
SUPPLIES:
Cotter pins
Pencil
Pin (1/8 in. diameter welding rod, 4 in. long)
Paper
REFERENCE:
PRELIMINARY PROCEDURES:
Remove transmission stroud (page 9-2)
Block vehicle tracks (TM 5-5420-226-10)
CABLE ADJUSTMENT:
1.
Set transmission shift lever to P (park) position (TM 5-5420-226-10 ).
2.
Using pliers, remove cotter pin (A) and pin (B) holding brake cable clevis (C) to parking
brake lever (D). Throw away cotter pin (A).
TA169250
Go on to Sheet 2
