TM 5-5420-226-20-3
PARKING BRAKE PAWL AND BELL CRANK ADJUSTMENT (Sheet 3 of 4)
Usin-- two 9/16 inch wrenches, loosen two nuts (J) on end of cable (K). Do not allow
g
5.
cable to turn or damage to cable will result.
6.
Pull push cable (K) down until 1-1/8 inch
gage block just fits between cotter pin (L)
and sleeve nut (M).
7.
With gage block in place, rotate upper
nut (J) until metal-to-metal contact
exists between upper nut (J) and lever
assembly (F).
Using 9/16 inch wrench, back off upper
8.
nut (J) 1-1/2 to 2 turns, then do steps
9 thru 19.
While holding upper nut (J) in place with 9/16 inch wrench tighten lower nut (J) securely
9.
with another 9/16 inch wrench. Do not allow cable to turn, or damage to cable will result.
TA169256
Goon to Sheet 4
13-132