TM 5-5420-226-20-3
TRACK ASSEMBLY REPLACEMENT (Sheet 2 of 10)
NOTE
Disconnect track up front between
compensating
idler Wheel and
roadwheel at position No. 1 (on
either side).
REMOVAL:
1.
Using 15/16 inch socket with ratchet,
loosen bolt (A) securing wedge (B) to end
connector (C).
2.
Using hammer, tap wedge (B) to loosen
it.
3.
Remove bolt (A) and wedge (B). Discard
bolt (A) and wedge (B).
4.
Repeat steps 1 thru 3 to remove bolt and
wedge at opposite side of track.
Put hook (D) of track end connector puller and
5.
pump behind end connector (C).
6.
Aline studs (E) of puller with shoe
pins (F).
7.
Pump handle (G) until gap between end
connector (C) and track shoes (H) is about
1 inch.'
Go on to Sheet 3
l4-66
Change 3
