TM 5-5420-226-20-3
TRACK ASSEMBLY REPLACEMENT (Sheet 1 of 10)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
Instillation
TOOLS: Sledge hammer
15/ 16 in. socket with 3/4 in. drive
Hinged handle ((breaker' bar) with 3/4 in. drive
Ratchet with 3/4 in. drive
2 lb hammer
Crowbar, pinch point
1-5/16 in. socket with 3/4 in. drive
1-1/2 in. socket with 3/4 in. drive
Torque wrench with 3/4 in. drive (0-600 lb-ft) (0814 Nm)
10 in. extension with 3/4 in. drive
SPECIAL TOOLS: Track end connector puller and pump (Item 10, Chapter 3, Section I)
Track torquing tool kit (Item 13, Chapter 3, Section I)
Track connecting fixture (Item 18, Chapter 3, Section I)
SUPPLIES Rope (Item 78, Appendix D) (50 ft.)
Three
PERSONNEL:
REFERENCES:
Loosen track tension (TM 5-5420-226-10).
PRELIMINARY PROCEDURE:
Remove rear fender and shield (if required) (page 16-57)
Go on to Sheet 2