TM 5-5420-226-20-3
TRACK ADJUSTING LINK REPAIR (Sheet 2 of 3)
3.
Place link (B) in a vise and
using hammer on chisel, cut stakes
at three places (both sides) that hold
bearing (E) in eye end of link (B).
4.
Position inserter and remover to bearing
(E) in link (B). Using 3/4 inch siding tee,
press bearing (E) out of link eye.
5.
Inspect parts (A) through (E). Replace them
as necessary.
ASSEMBLY:
1.
Position link (A) so eye end is facing upward.
NOTE
Make sure bearing (B) is evenly
mounted in link eye.
2.
Using inserter and remover, carefully press
bearing (B) into eye of link (A).
Go on to Sheet 3
Change 3
14-81