TM) 5-5420-226-20-3
TRACK ADJUSTING LINK REPLACEMENT (Sheet 4 of 5)
INSTALLATION:
Before mounting link (A), position it so lubrication
fitting is on top (pointing outward).
Rotate arm until link mount is above slope at
front of vehicle.
With help of second technician, lift link
(A) into mounted position on vehicle.
Aline pin (B) grooves with two splines in
bearing. Insert pin (B) from hull side
(threads facing away from hull).
Using hammer, drive pin (B) into place
5 ' through link (A).
6.
Lower arm and position other end of link (A) on mount at roadwheel.
7.
Aline pin (C) with two splines in bearing.Insert pin (C) from outside (threads
facing toward hull).
Using hand to hold shim (D) in place between mount and pin (C), use hammer and drive
8.
pin (C) through link (A).
Go on to Sheet 5
TA169342