TM 5-5420-226-20-3
STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 2 of 22)
ADJUSTMENT:
NOTE
When the engine, transmission, or entire powerplant is
exchanged in a vehicle, driver's steering control must be
checked for centering and adjustment. If the vehicle cen-
tering and linkage adjustment was satisfactory before the new
powerplant was installed, go to step 119.
NOTE
Check to make sure rod end bearings are serviceable before
proceeding with any linkage adjustments.
NOTE
It may be necessary to manually move link assembly be-
fore locating pin (P) can be inserted.
1.
Insert locating pin (A).
2.
Check to see
if driver's steering control
If steering control (B) is
(B) centers.
on to step 3. If steering
centered, go
control (B) is
not centered, go on to step
27.
TA169392
Go on to Sheet 3
15-32
