TM 5-5420-226-20-3
STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 6 of 22)
Using 9/16 inch wrench to hold steering
20.
rod end (K), use 9/16 inch wrench to
loosen jamnut (N).
Using hands, turn control rod (J) clock-
21.
wise until control rod (J) is just past
witness hole in steering rod end (K).
Using 9/16 inch wrench, to hold steering
22.
rod end (K), use 9/16 inch wrench to
tighten jamnut (N).
Using 9/16 inch wrench, turn steering rod
23.
end (F) counterclockwise until screw (E)
will drop freely through clevis (G) and
steering rod end (F).
24.
Using 9/16 inch wrench, install screw (E)
through clevis (G) and steering rod end
(F).
Using socket and torque wrench, tighten
25.
screw (E) to 16 lb-ft (22 N m).
Using 9/16 inch wrench to hold steering rod end (F), use 9/16 inch wrench to tighten
26.
jamnut (H).
Remove locating pin (A).
27.
TA169396
Go on to Sheet 7
15-36
