TM 5-5420-226-20-3
REAR FENDER PLATE, SHIELD, AND SUPPORT REPLACEMENT (Sheet 4 of 5)
NOTE
Do not tighten screws and nuts at this time.
It may be necessary to move plate to aline
mounting holes.
INSTALLATION:
1. Position pad (A) on support plate
(B).
2. Using two 7/16 inch wrenches, install
three washers (C), screws (D),
lockwashers (E) and nuts (F).
3. Position support plate (B)
on bracket (G).
Using two 9/16 inch wrenches, install screw
4.
(H), two washers (J), and lockwashers
5.
Place pad (L) in position on shield (M).
6.
Using two 7/16 inch wrenches, install nine
screws (N), washers (P), lockwashers (Q), and
nuts (R).
Go on to Sheet 5
