TM 5-5420-227-24
CUPOLA COVER HANDLES REPLACEMENT (Sheet 2 of 2)
INSTALLATION:
1.
Manually slide outside handle
(A) through cupola cover(B).
2.
Manually install woodruff key (C).
NOTE
If only outside handle was replaced,
go to step 6.
3.
Place hook (D) and shims (E), if any,
in position on inside handle (F).
4.
Manually install two screws (G).
5.
Using wrench, tighten two screws (G).
6.
Manually slide inside handle (F)
into position on shaft of outside
handle (A).
7.
Manually install new lockwasher (H)
and nut (J).
8.
Using 15/1 6 inch socket, tighten
nut (H).
From inside vehicle, close cupola cover (B).
9.
10.
Have second technician hold down cover (B) from outside of vehicle while
performing next step.
11.
Latch inside handle (F) to see that hook (D) properly contacts
locking lug (K) and seals cupola cover (B).
12.
If hook (D) does not contact lug (K) or seal properly, add or remove
shims (E) as needed between hook (D) and inside handle (F).
End of Task
TA170244
3-16