TM 5-5420-227-24
TONGUE CYLINDER HOSE ASSEMBLIES (CT, DA3, AND DA4) AND HYDRAULICS REPLACEMENT
(Sheet 2 of 4)
NOTE
Hose assembly in step 7 is being removed to
provide wrench clearance for removal of parts
in the following steps.
7.
Using adjust able wrench to hold elbow (K), use 1-1/4 inch wrench to disconnect hose
assembly "CP1" (L).
Using adjustable wrench to hold elbows (M),
8.
use 1-1/4 inch wrench to disconnect hose
assemblies "DA3" (H) and "DA4" (B) from
elbows (M).
Using adjustable wrench to hold elbows (M),
9.
use 1-1/4 inch wrench to loosen nuts (N).
10.
Using adjustable wrench, remove two elbows
(M).
Manually remove packings (P), flat washers
11.
(Q), and nuts (N) from elbows (M). Throw
packings (P) away.
INSTALLATION:
NOTE
Before installation, use pipe tape on all male threads. Start
tape on second thread so tape will not enter hydraulic system.
Using 1-1/4 inch wrench, install adapter (A)
1.
and new packing (B).
Manually install tee (C), nut (D), and new
2.
packing (E) into valve body (F).
TA170387
Go on to Sheet 3
3-161