TM 5-5420-227-24
OVERHEAD CYLINDER HOSE ASSEMBLIES (DA5 AND DA6) AND HYDRAULICS REPLACEMENT
(Sheet 2 of 3)
NOTE
Hose assembly in step 6 is being removed to
provide wrench clearance for removal of parts
in the following steps.
6.
Using 1-1/4 inch wrench remove hose
assembly "DA2" (K) from elbow (L).
7.
Using 1-1/4 inch wrench, remove hose
assemblies "DA6" (C) and "DA5" (B).
8.
Using 1-1/4 inch wrench, loosen elbow nuts
(M).
Using adjustable wrench, remove elbows (N),
9.
nuts (M), flat washers (P), and packings (Q).
Throw packings (Q) away.
INSTALLATION:
NOTE
Remove caps and plugs as necessary during installation. Tape
all male threads before installation with pipe tape:
1.
Manually install nuts (A), flat washers (B),
and new packings (C) onto tees (D).
2.
Manually install and aline tees (D).
3.
Using adjustable wrench to hold tees (D),
use 1-1/4 inch wrench to tighten nuts (A).
4.
Using adjustable wrench to hold tees (D), use 1-1/4 inch wrench to install adapters (E).
5.
Using adjustable wrench to hold tee (D), use 1-1/4 inch wrench to install hose assembly
"DA5" (F).
6.
Using adjustable wrench to hold tee (D), use 1-1/4 inch wrench to install hose assembly
"DA6" (G).
TA170390
Go on to Sheet 3
3-165