TM 5-5420-227-24
PU M P-CLU T CH SU PPORT REPLACEM EN T (She e t 1 Of 1)
TOOLS: 9/16 in. socket with 1/2 in. drive
Ratchet with 1/2 in. drive
1/4 in. drive pin punch
3/4 in. socket with 1/2 in. drive
10 in. extension with 1/2 in. drive
Hammer
Lockwashers (8 required)
SUPPLIES:
Lockwashers (4 required)
Remove pump (page 4-29)
PRELIMINARY PROCEDURES:
Remove clutch controls (page 4-27)
REMOVAL:
1.
Using 9/16 inch socket, remove four
screws (A) and lockwashers (B).
Throw lockwashers (B) away.
Using punch and hammer, drive out
2.
spacer (C).
Using 9/16 inch socket and extension,
3.
remove eight screws (D) and lock-
washers (E). Throw lockwashers (E) away.
Using 3/4 inch socket, remove two
4.
screws (F).
Remove pump-clutch support (G).
5.
INSTALLATION:
Place pump-clut ch support (G) in position in
1.
vehicle.
2.
Using 3/4 inch socket, install two screws (F).
Using 9/16 inch socket, install eight screws (D) and new lockwashers (E).
3.
4.
Using hammer and punch, drive spacer (C) into place.
5*
Using 9/16 inch socket, install four screws (A) and new lockwashers (B).
6.
Install pump (page 4-30).
7.
Install clutch controls (page 4-28).
TA170510
End of Task
4-32
