TM 5-5420-227-24
TONGUE CYLINDER REPAIR (Sheet 5 of 5)
Remove tape from threads of
13.
piston rod (B).
Using second technician, manually
140
start rod end connector (Q) on
cylinder rod (B).
Have one technician use piston rod wrench on flats of cylinder rod (B) and second technician
15.
insert pin (R) through rod end connector eye (S).
Using pin (R) as a lever, turn rod end connector (Q) clockwise and tighten.
16.
Service hydraulic reservoir (LO 5-5420-226-12).
17.
Bleed hydraulic system (page 3-66).
18.
Extend tongue piston rod (B) and position rod end connector (0) into tongue (T)
19.
Have one technician hold rod end connector (Q) in position while second technician inserts
pin (R) through rod end connector (Q).
Using snap ring pliers, install two
21.
retaining rings (U).
Using 7/16 inch socket, install two
22.
grease fittings (V).
Remove wooden block from beneath
23.
cylinder tongue (C).
Check for hydraulic leaks and correct
24.
as necessary.
Service hydraulic reservoir
25.
End of Task
4-81